How do you use the numbers on the raft receiver?
Once all the antenna is set, turn on the receiver and place the code of the tower. To find the code of the tower press “T” on the keyboard or open your journal. To change the numbers you will have to press the up or down button and the change, the position of the numbers interacts with the side lever.
Where is the raft code?
Check your journal (T). Codes allow you to locate story locations. There are currently three: The Radio Tower, The Vasagatan and The Balboa Island. You can find new code in each location.
How do you cheat on the raft?
Raft Cheats Commands
- Hunger: /set hunger X, where X is the value.
- Thirst: /set Thirst X, where X is the value.
- Blockhealth: /set Blockhealth X, where X is the value.
- Bonushunger: /set Bonushunger X, where X is the value.
- Gamemode: /set Gamemode X, where X is the value.
- FPS: /set fps X, where X is the value.
Where is the four digit code in raft?
The Four Digit Code can be found in the room adjacent to the helipad. It opens the safe containing the Electrical Wires needed for the Bomb.
How do you build a second floor in the raft?
You need to hold the right mouse button and build posts and stairs. every post allows floor expansion of 3×3. For the floors you hold right mouse button and use floors.
How do you get a raft engine?
The Engine is acquired through the Blueprint: Engine found on the Vasagatan. After researching the blueprint, players may build and place an engine in order to sail against the wind. Used in combination with the Steering Wheel, the player gets full control of which direction they wish to sail.
How do you use raft commands?
How do I use the Raft console commands?
- Press the Enter key to enable the chat window.
- Now, type all the commands you want to use and hit Enter again.
Is Tangaroa the end of raft?
Tangaroa is the final location of the Second Chapter.
What do the green dots mean on the radar in Raft?
The Receiver can be placed anywhere, as long it isn’t too close or too far from the Antennas. Make a battery and place it into the battery slot on the Receiver and turn on the Receiver. If done right, a RADAR-like screen will turn on, and show a green dot for a location of interest.