Can I wash my longboard?

Is it bad to get longboard wet?

As much as possible, try to avoid getting your skateboard wet. Water is bad for the bearings, board, trucks and bolts. Plus, you might have to deal with hydroplaning, which could affect your ability to control the skateboard. So, try not to skate in the rain or through puddles.

How often should I clean my longboard?

Remember, bearings only need to be cleaned about once every two to three months depending on the environment you are skating in. If you primarily skate inside several times a month but the surface is not cleaned often, you might have to shine up your bearings once a month.

How do I make my longboard wheels clear again?

Put some dishwashing soap in a larger sized bowl and then fill with warm water. Drop your wheels into the bowl and let them soak for a bit. 10-15 minutes ought to do it. Pull the wheels out and use a rag to scrub with the soapy mixture.

How do you clean a wet longboard?

Wash your board down with water and a mild dish soap.

Soap will keep your board clean and can prevent mildew and bacteria from growing on it. Saturate a sponge with soap and water and use to clean your board. Once you’ve covered the entirety of the board, rinse it off with a hose.

IT IS INTERESTING:  What should I bring snowmobiling?

Can you skate on wet pavement?

Skating in the rain or even just on damp ground can affect your bearings and reduce their efficiency. After a wet skate it’s important to clean your bearings to ensure no permanent damage is done.

Do longboard wheels wear out?

While softer wheels wear down more easily you’ll have a bad time using hard wheels on a longboard. If your wheels aren’t spinning properly this doesn’t mean you have to replace them. … Just make sure you maintain your wheels so you don’t have to worry about buying a new set.

Can you use alcohol to clean bearings?

Soak bearings in isopropyl alcohol

With the bearings completely relieved of their shields, place each bearing in the cup and let the alcohol work its magic. You will want to leave them in there for a minimum of 30 mins with occasional swishing and swirling of the bearings.

Can you use WD40 on longboard bearings?

Can you use WD40 on skateboard bearings? NO. WD40 is a degreaser – not a grease!! The object of cleaning your bearings is to remove all the grease, clean the bearings, then add grase back in.

How do you fix a slow longboard wheel?

Action 1 : Loosen your axle nut to make your longboard faster. This is an easy one : if your axle nuts are too tight they can keep your wheels from spinning freely. That may be a reason why your longboard feels slow. Loosening the nuts a bit can allow your wheels to spin normally again.